Saturation Temperature in HVAC Explained
Learn how refrigerant pressure maps to saturation temperature, why line temperature is different, and when dew or bubble references matter.
-
-
4 Ton Cooling Capacity Explained: BTU, CFM, and Delivered Cooling
A 4 ton AC is nominally 48,000 Btu/h of cooling capacity, but delivered cooling depends on conditions, airflow and installation.
-
Furnace Starts Then Shuts Off After a Few Minutes
A furnace that lights and stops early may be losing flame proof, opening a limit, or ending the heat call. Use timing and safe observations to narrow it down.
-
Cooling Design Temperature Explained for AC Sizing
Cooling design temperature is a local sizing condition, not the hottest temperature the city has ever reached.
-
How HVAC Airflow Problems Distort Refrigerant Readings
Dirty filters, blower settings, coil restrictions and duct pressure can alter suction, superheat and subcooling. Learn why airflow is verified before charge.
-
Heat Pump Capacity at 47°F vs 17°F: How to Read Ratings
Learn what 47°F and 17°F heat-pump capacity ratings show, why matched-system data matters, and how to compare low-temperature output without guessing.
-
Furnace Blowing Cold Air: Normal Startup or a Heating Problem?
Learn when cool air from furnace vents is normal, how fan timing and burner shutdown change the symptom, and when measurements or service are needed.
-
Fan ON vs AUTO: Which Thermostat Setting Controls Humidity Better?
AUTO usually stops the blower with cooling; ON circulates continuously. Learn how wet-coil re-evaporation, ventilation and system design affect humidity.
-
What Is an Orphaned Water Heater?
Removing a furnace from a shared chimney can leave an atmospheric water heater unable to warm and draft through the oversized vent reliably.
-
2000 CFM to Tons: How to Convert Airflow to Nominal Cooling Capacity
At 400 CFM per ton, 2,000 CFM corresponds to about 5 nominal tons; at 350 CFM per ton it corresponds to about 5.7 nominal tons.